Промышленное предприятие ЗИП

Range of products

Показать фильтры товаров
Показать категории

Enamel with hammer effect anticorrosive 3in1 serias Kolchuga ZEBRA

Download sanitary and hygienic conclusion Download technical card
Write expert
    • Drying time

      “На відлип” – 30 хвилин, остаточний час висихання 2 години

    • Coverage

      100-150 gr/m² depending on color

    • Тhinner

      Solvent or xylene

    • Type of works

      Inside and outside the permises

    • Containers

      0,7 kg

Value of the Product:

  • Applies directly on the rust
  • Doesn’t need priming
  • Ideal for metal protection

Prescription:
For protective decorative painting metal surfaces with corrosion traces up to 100 microns. It can be used as a standalone coating. For external and internal works

Surface preparation:

  • Before painting the surface should be cleaned mechanically from old peeling paintwork and rust
  • Applying on old coatings, check the compatibility of this coating with the enamel by trial application on small area (after enamel drying there shouldn`t be soaking, wrinkling, folds)
  • In case of incompatibility, remove the old paintwork completely
  • In case of incompatibility, completely remove the old paintwork
  • File down the surface with sand paper and remove the dust
  • Degrease the surface with solvent or liquid №646, №647 TM ZEBRA
  • Painted surface must be dry

Painting:

  • Stir the enamel thoroughly before painting
  • If there is a surface film, it must be removed
  • If necessary, dilute with solvent until the working viscosity
  • Work should be conducted at a temperature not lower than + 5°C and not higher than + 35°C
  • When applied with a roller or brush, dilute to 3%, with a pneumatic sprayer – up to 10%
  • To achieve a high-quality coating, apply enamel in 2-3 layers crosswise with intermediate drying for 15-20 minutes (wet on wet) at a temperature 20°C with a total dry film thickness of at least 70 microns
  • If it is not possible to maintain the specified drying interval between the layers, the next layer should be applied not less than 4-7 days because of the likely interlayer dissolution of the enamel not up to the end of the formed coating and the appearance of shagreen

Thinner: Solvent or xylene

Storage, transportation and disposal:
Keep out of children’s reach.Store and transport in a tightly closed original container protected from moisture and direct sunlight. Not afraid of frost. Closed container with the remains of the product should be disposed in the special organized places for collecting of household waste. Keep away from fire.

Оur brands
Оur partners
закрыть

Fieldset

 

Verification

закрыть

Supplier Data

  • Section

 

preloader